AMX PTM-D15 - Manual (Page 29)

Configuration and Setup
23 PTM-D15 15" Platinum Touch Panel
14. Once in the calibration mode, press the middle of the on-panel cross-hairs as they appear. After
the last cross-hair has been depressed and the coordinates points have been set, a dialog
displays the panel coordinate values.
15. Press the screen to exit from the calibration session and return to the panel display.
16. Select Connect > Disconnect to exit from telnet session and close the NetLinx Studio Program.
Send_Command, <TPI/3 device number>,"’calibrate’"
Example:
Send_Command 130,"’calibrate’"
Sets up the panel to begin the calibration process. Touch the cross-hairs that appear on the panel to
complete the calibration process.
PRGM EX. 15