ADC MM701G2 - Manual (Page 54)

Chapter 5: Configuring System Parameters April 14, 2006
5-12 MM70xG2-UM-03
S AVING C HANGES
Use the Save Changes page for saving your current configuration to flash memory. This option immediately writes
all current system configuration to permanent memory (NVRAM). You cannot selectively write configuration to
NVRAM. When you issue the save command, all current configuration is written to NVRAM.
Note: When saving the modem configuration, do not power off the modem while the save is in process.
Step Action
1 Select Save Changes on the menu bar to access the Save Changes page ( Figure 5-12 ).
Figure 5-12. Save Changes