ADC MM701G2 - Manual (Page 97)

April 14, 2006 Appendix A: Command Line Interface Access
MM70xG2-UM-03 A-9
Add a New Session
Step Action
1 On the WAN Session Management menu, enter 2 to add a new session. The Create new session menu
is displayed (
Figure A-8 ).
Figure A-8. Create New Session
2 Select one of the following protocols for this session:
1—Create RFC 1483 bridged session if the modem forwards packets based on MAC addresses.
You can enable Spanning Tree when you select Bridge sessions. See
“Change Spanning Tree
Setting” on page 5-10 .
2—Create RFC 1483 routed session if the modem routes packets based on IP addresses.
3—Create PPPoA routed session if the modem establishes PPP sessions over ATM with the
service provider and routes packets based on IP addresses.
4—Create PPPoE routed session if modem establishes PPP sessions over Ethernet with the
service provider and routes packets based on IP addresses.