HOUNO C, K & C-gas ovens - Manual (Page 12)

SETTINGS
12 USER MANUAL C, K & C-GAS
6. To leave text editing without storing, press ALARM. The original text reappears.
7. To delete the entire text, press the programmes key and ALARM simultane-
ously for 2 seconds.
When a key or the turn knob is idle for 20 seconds, the oven returns to select
programme .
Entering and changing data in steps
By pressing STEP when PROGRAMME is active, the step display is turned on and shows
”1”. The data of the first step can now be entered.
To move on to the next step (1-10) and read and change settings, press STEP again.
Choose and change temperature, time, core temperature, damper and fan as in manual
operation.
Stop between steps: To turn the alarm between steps on and off, press ALARM. If the
control lamp is on, the programme ends with the current step and a beep is heard. The
oven does not proceed to the next step until the oven door is opened and closed or you
press ALARM.
To store a change made in the step mode, press the programmes key for 2 seconds.
Leave STEP by choosing another programme with the turn knob.
Be careful not to use the turn knob when a value flashes. If you
turn the knob while you are working in STEPS, the computer
switches to the next programme and all changes are lost.
Delete current step by pressing STEP and ALARM simultaneously for 2 seconds.
When the programme has started, you can still change time, temperature, core temper-
ature and the settings of fan and damper. These changes will then only be active in the
current run. Note that the display shows the total time remaining after start and that it
will show the time remaining in the current step when you press TIME.