Pitco Frialator Solstice I12 Cooking Computer Single Vat - Manual (Page 5)

Solstice I12 Cooking Computer Operations
Single Vat (60126801) and Dual Vat (60126802)
L20-282 Rev 0 (2/07) 5
1 2 2
0 0 1
Level 1 & 2 Password
6 8 6 4
1.7.2 Manual Boil Entry:
After filling an empty vat with water, turn the appliance on. Press the
thermometer key and enter key sequence [2], [1], [2]. If control is set
to display in the Celsius scale, press [1], [0], [0] keys to manually
enter boil mode. The display will show [ BOIL ] to indicate entry into
boil mode.
To exit boil mode, control must be turned off.
2 To Enter Programming Level 1 (for the Store Manager):
Note: The factory default setting for this control does not require an operator password to
be entered. However, the operator password requirement and value may be
changed in section 3.2. This text assumes the operator password is disabled. Entry
of a password when NOT required will not interfere with the programming process.
With no cook timers running, displays will show one of the following displays: [HEATING], [MELT]
[LIQUID (or SOLID)], or [READY].
Press the [P] program key. Left display will show
[PROGRAM]. Right display will be blank.
Enter password 6684 using the product keys as numeric keypad for entry.
Display still shows [PROGRAM].
From the [PROGRAM] display, continue with this section or go to section 3.
2.1 To Set Cook Temperature:
Press the thermometer key once for Single Vat (left side of Dual Vat) or press key twice
for Dual Vat (right side of Dual Vat).
The display will show [SET xxxF] [TEMP] or [SET xxxC] [TEMP], where “xxx” is the
temperature setting. Use the product keys for numeric entry to adjust the current
setting. Press the [P] key to save setting. Display now shows [PROGRAM]. To exit
here, press [P] again, or continue.
2.2 To Change a Product Key–Cook, Shake, Hold, and Hold Pre-Alarm Times:
For each product key, Cook, Shake, Hold, and Hold Pre-alarm times are set in this section. With
display showing [PROGRAM], continue with the following section for each product key to change.
2.2.1 Cook Time
Cook Time may be set for each product key. To deactivate any product key enter a zero
value for cook time.
Press the [Clock] key. Display will show [SELECT] [PRODUCT]. Press the desired
product key to change.
The display is now showing [nCK mm:ss] [TIME] where “n” is the key number,
“CK” means Cook, and “mm:ss” is minutes and seconds. Use the product
keys for numeric entry to adjust the current setting. Press the [Clock] key to
save cook time and continue setup for this product key.