Pitco Frialator Solstice I12 Cooking Computer Single Vat - Manual (Page 8)

Solstice I12 Cooking Computer Operations
Single Vat (60126801) and Dual Vat (60126802)
L20-282 Rev 0 (2/07) 8
5
6
7
8
3.5 Melt Cycle Type:
This adjustment allows selection of the melt cycle type, or, disabling the melt cycle requirement
when starting the appliance from a cold start.
With display showing [PROGRAM], press the product key [0].
Display will show [SELECT] [OPTIONS].
Press product key 5, display shows [LIQUID], the default setting.
Use the product key [0] to scroll through choices (liquid, solid, no melt).
Press [P] key to save choice. Display will again return to [PROGRAM].
3.6 Recovery Test Value:
This controller maintains a record of heat up times for the appliance. A poorly running appliance
will have increased recovery times stored in this display. There is no selection done here, just the
display of recovery time values.
With display showing [PROGRAM], press the product key [0].
Display shows [SELECT] [OPTIONS].
Press product key 6; display will show [RECOVERY] [TEST].
Press the product key [0]. Display will show [FnnnLyyy], where nnn is the factory recovery value,
and yyy is the last warm up recovery value.
After recording these values, press the [P] key. Display returns to [PROGRAM].
3.7 Control or Timer: (Left side of Dual or Single Vat)
With display showing [PROGRAM], press the product key [0].
Display shows [SELECT] [OPTIONS].
Press product key 7; display will show [CONTROL].
Use the product key [0] to scroll through choices (Control, Timer).
Press [P] key to save choice. Display shows [PROGRAM].
Note: If timer is selected, heat control outputs are disabled, leaving only the timer functions
active. Do not make this selection on Solstice fryer models.
3.8 Control or Timer: (Right side of Dual Vat)
Note: This key has no function of single vat controls.
With display showing [PROGRAM], press the product key [0].
Display shows [SELECT] [OPTIONS].
Press product key 8; display will show [CONTROL].
Use the product key [0] to scroll through choices (Control, Timer).
Press [P] key to save choice. Display shows [PROGRAM].
Note: If timer is selected, heat control outputs are disabled, leaving only the timer functions
active. Do not make this selection on Solstice fryer models.