Power Soak 33639 SILVERWARE PRE-WASHING SYSTEM INSTALLATION MANUAL - Manual (Page 4)

4
Drop-in Version Installation Steps
1. Lay out the opening to be cut in the dish table top.
2. Choose one of the three suggested faucet hole locations.
3. Cut and deburr the openings.
4. Remove and set aside the clamp flange nuts, the clamp frame, and in the case
of the High Capacity unit, the legs.
5. Remove all traces of grit, oil, and marking dye from the top of the opening.
6. Place the gasket around the opening ON THE TOP OF THE DISH TABLE.
7. Lower the tank into the opening being careful not to scrape the front face of
the tank with its control box mounting studs.
8. Pass the clamp frame over the tank from below and raise it into position over
the clamping studs.
9. Install the clamp flange nuts and tighten them evenly until the gasket is
uniformly squeezed.
10. If installing a High Capacity unit, fit the legs at this time. Adjust the feet so
that the dish table is flat and will not collect water around the tank flange.
11. Use a sharp knife to trim the excess gasket away from the tank flange.
12. Install the faucet, drain connection, and control box according to the
Electrical and Plumbing Requirements detailed above.
13. Wire the unit according to the Electrical Power and Electrical Wiring
Requirements detailed above.
14. Test the unit for water leakage, acceptable motor current, and proper
function.