Power Soak 33639 SILVERWARE PRE-WASHING SYSTEM INSTALLATION MANUAL - Manual (Page 5)

5
Weld-in Version Installation
Review the drawings that came with the unit to confirm that the location chosen for
the system is adequate with respect to:
• Drain proximity
• Electrical power proximity
• Adequate space on the dish table top for the tank and the faucet
• Appropriate location for the control box bracket
• Absence of ribs or other features on the underside of the selected dish table
location
Weld-in Version Installation Steps
1. Lay out the opening to be cut in the dish table top.
2. Choose one of the three suggested faucet hole locations.
3. Cut and deburr the openings.
4. Remove all traces of grit, oil, and marking dye from the opening.
5. Set aside the main assembly and work only with the collar for the next few
steps. DO NOT remove the wooden shipping cover from the collar.
6. Place a temporary support on the floor below the collar to lift the collar to the
bottom of the dish table.
7. Shim the temporary support until the collar just touches the underside of the
dish table. The cut-out shown in the included drawing is based on the dish
table half-lapping the top edge of the collar, that is, with a 0.037 inch gap
between the edge of the dish table cut-out and the inner wall of the collar
on all four sides.
8. Using Gas Tungsten Arc Welding (TIG) equipment, tack weld the collar to the
dish table. Fillet-weld the underside of the joint with an 1/8 inch bead all
around. To prevent distortion, consider skipwelding around the collar in
multiple steps until the entire joint is complete.
9. Outside-corner-weld the top side of the joint all around.
10. Grind and polish the top side weld until a sanitary finish is achieved.