Pulsafeeder PULSAtron Series MP EN - Manual (Page 2)

2
SAFETY INSTRUCTIONS
When using chemical feed pumps, basic safety precautions
should always be followed to reduce risk of fire, electric
shock, and personal injury. Failure to follow these
instructions could result in death or serious injury.
READ ALL INSTRUCTIONS
*** : Secure chemicals and metering pumps, making them inaccessible to children and pets.
*** DO NOT PUMP FLAMMABLE LIQUIDS.
*** Do not cut the plug or ground lug off the electrical cord. Consult a licensed electrician for proper installation or
replacement.
** : Always wear protective clothing, including gloves and safety glasses, when working on or near
chemical metering pumps.
** Inspect tubing regularly for cracking or deterioration and replace as necessary. (Always wear protective clothing
and safety glasses when inspecting tubing.)
** Use CAUTION to keep fingers away from rotating parts.
** If pump is exposed to direct sunlight, use a UV resistant tubing.
** Follow directions and warnings provided from the chemical manufacturer. The user is responsible for determining the
chemical compatibility with the chemical feed pump.
** Make sure the voltage on the pump name tag matches the installation voltage. If pump fails to start, check line
voltage.
** Consult with local health officials and/or qualified water conditioning specialists when treating potable water.
** Always depressurize system prior to installation or disconnecting the metering pump tubing.
** If injection point is lower than the chemical tank and pump, install an anti-siphon valve.
** DO NOT MODIFY PUMP. This poses a potentially dangerous situation and will void the warranty.
* : All pumps are factory tested with water. Remove tubing and thoroughly dry if the chemical being
pumped will react with water (for example sulfuric acid).
* Hand tighten plastic connections (Do not use wrench).
* Consult licensed plumber and electrician before installation to conform to local codes.
* NOTE: For accurate volume output, pump must be calibrated under all operating conditions.