Pulsafeeder PULSAtron Series MP EN - Manual (Page 30)

30
REPAIR SERVICE
Normally following the instructions in the previous sections of the manual will rectify any pump problems. If, however, after
following these instructions the pump does not perform properly, it can be returned for repair. Please follow the
instructions below:
1. Pump cannot be serviced properly if the original pump nameplate or data contained on the nameplate is not intact.
2. Thoroughly flush pump head and outside of pump with water or a suitable fluid to neutralize any residual chemical left
in pump.
3. Include written explanation of the following:
A) Problem
B) Pumped Fluid
Name
Viscosity
Fluid Temperature
C) Pressure @ Discharge
@ Suction
or Suction Lift
D) Environmental Temperature
E) Electrical Service
Volts
Hz
Phase
F) Nameplate Data
Series
Serial #
KOPkit #
4. Package the pump in the original box if available and send to the address specified by your pump supplier.