Vaddio WideSHOT WallVIEW Mini - Manual (Page 11)

WideSHOT WallVIEW Mini
WideSHOT WallVIEW Mini, Document Number 342-0710 Rev B Page 11 of 32
Diagram: Basic System Configuration WideSHOT with USB Mini
W
IDE SHOT C AMERA - F IRST T IME S ET - UP
The WideSHOT was designed to be very easy to use and operate. There is
documentation at the back of this manual for pin-outs for the connectors on the
WideSHOT camera and the USB Mini Interface.
Before Installing the Camera:
 Choose the camera mounting location while paying close attention to camera
viewing angles, lighting conditions, possible line of site obstructions and
checking for in-wall obstructions where the camera is to be mounted. Always
pick a mounting location that will optimize the performance of the camera.
 Please locate the camera to enable easy positioning of the camera body with
the ability to point down and away from the ceiling and a bunch of fluorescent
lighting cells. Cameras generally don’t like to be swamped with fluorescent
light and very few people sit on the ceiling anyway.
 The Thin Profile Wall Mount for the WideSHOT can be mounted directly to a 1-gang wall box or can be
mounted using two (2) provided spiral dry wall anchors.
 For Power/Video and RS-232 signals, use standard Cat-5 cable (568B termination and real RJ-45
connectors) from the EZ-POWER VIDEO and RS-232 ports on the back of the WideSHOT to the Quick-
Connect USB Interface. The EZ-POWER VIDEO jack on the camera is marked in
red as a reminder that
there is 24 VDC power on that Cat-5 cable.
Image: WideSHOT HD
Camera with provided
Thin Profile Wall Mount
Local
Power
24 VDC
USB 2.0
Connected
to Front
Panel
Serial Control (RS-232)
◄ HD Video from Camera - Power to Camera ▶
Laptop with UC
Application
Room Monitor
(Simulated video feed)
HD Video
(HDMI, DVI
or RGBHV)
Quick-Connect USB Mini
Rear Panel (above), Front Panel (below)
Two (2) Cat-5 Cables
Distance up to 150’ (15.26m)
WideSHOT HD
Camera
USB 2.0
(UVC
Drivers)
Extension of PC Video
to Room Monitor