Installation – Yorkville LP-DMX3/5 User Manual
Page 3
Advertising
Installation
The LP-DMX3/LP-DMX5 installation kit should include the LP-DMX3 or
LP-DMX5 plug-in module, a 4-wire connecting cable and this manual.
CAUTION: DISCONNECT THE POWER CORD
BEFORE PROCEEDING!
Just left of center on the LP-LED4 light bar, there is a knockout panel.
Using the straight-bladed screwdriver, pry it off and remove it.
There are Phillips screws at the four corners of the resulting hole. Remove
them and set them aside for use later.
Advertising