Yorkville LP-DMX3/5 User Manual
Page 4
Advertising
If there is a clamping screw in the stand adapter at the center of the LP-
LED4, remove it and set it aside.
Make sure the LED pods are level and the tilt clamping knobs on all four are
tight. Turn the LP-LED4 over so it rests on the pods. Remove the Phillips
screws holding the bottom cover on and remove the cover.
Plug one end of the 4-wire cable into the W2 connector on the LP-LED4
control board. The connector is polarized, so don’t force it.
Advertising