7 replacing the complete front assembly, Replacing the complete front assembly, 7 replacing the complete front as- sembly – Beijer Electronics iX TxA EN User Manual
Page 16
Advertising
TxA Maintenance
3.2.7
Replacing the Complete Front As-
sembly
The following is needed:
•
A new front assembly
•
A Torx TX10 screwdriver
Note:
Make sure to use adequate ESD protection.
Information about spare parts can be found in chapter
.
Follow the steps below:
1. Power off the operator panel.
2. Follow the instructions in chapter
Replacing the Back Cover and/or CPU Card
to remove the back cover (1).
3. Attach the new front assembly (2).
4. Re-assemble the unit.
Note:
Make sure that the display cable (3) fits correct and tight on both sides (Front and CPU)
according to the instructions in chapter
.
1
2
3
1. Back cover
2. Front assembly
3. Display cable
Beijer Electronics, MAEN021
16
Advertising