Beijer Electronics T15BR EN - Manual (Page 9)

Installation
2.2 Installation Process
A Thumb Screw Installation Tool (provided) or a slotted screwdriver is required
for installation.
1. Unpack and check the delivery. If damage is found, notify the supplier.
Note:
Place the operator panel on a stable surface during installation.
Dropping the operator panel or letting it fall may cause damage.
2. To cut a correct opening for the operator panel, use the cut out dimensions
in the outline drawing. A separate cut out drawing is available for download
from the Beijer Electronics web site. For more information, see sections
Operator Panel Drawings and Technical Data .
3. Secure the operator panel in position by screwing the slotted thumb screw
clockwise, allowing the built-in bracket to flip out and tighten against the
cabinet. Tighten the screws (12) to 0.7 Nm ±0.2 Nm.
4. For most applications, the provided Thumb Screw Installation Tool will
provide adequate torque. In cases where the front panel seal (IP66, NEMA-4)
is critical, a torque wrench should be used to ensure all twelve screws are
torqued within the specification above.
Thumb Screw Installation Tool
Beijer Electronics, MAEN165 9