Fagor 2MCF-2GSAXBUT User Manual

Page 13

Advertising
background image

1/ INSTALLING YOUR APPLIANCE

13

EN

Adjust the hob connections: these are

located underneath the control knobs
(Fig. 04).
— Proceed one tap at a time.
— Remove the control knobs and the gaskets
by pulling upwards.

- Switching from natural gas to
butane/propane

-

Using a small flat-head screwdriver, fully

tighten the brass burner power screws
(yellow)

(Fig. 05), in a clockwise direction.

-

Replace the gaskets and the control knobs,

noting their direction and ensuring that the
control knobs are fully inserted.

- Switching from butane/propane to natural
gas

-

Unscrew the brass (yellow) burner power

screws

(Fig. 05), using a small flat-head

screwdriver, turn twice anti-clockwise.

-

Replace the control knob.

-

Ignite the burner in maximum heat mode,

then turn down to reduced heat mode.

-

Remove the control knob again, then turn

the burner power screw clockwise until it
reaches the lowest possible setting without
extinguishing the flame.

-

Replace the gasket and control knob.

-

Repeatedly change from the maximum to

the minimum flow rate: the flame must not go
out ; if it does, unscrew the burner adjustment
screw to achieve good flame retention during
these changes.

-

Replace the burner heads, burner covers

and pan supports on the hob.

Sealing ring

Tap

Fig. 04

Fig. 05

Tap axis

Burner power
adjustment screw

Control Knob

Advertising