頁面 11 – MIPRO ACT-101 IR Remote-Controlled Single-Channel Diversity Receiver User Manual

Page 11

Advertising
background image

16

17

Charging the Transmitter Microphone:

!

Plug into an AC power outlet and the end into the charger itself.

!

Insert the transmitter into the battery charger. There are built-in contact points on both

sides of the battery charger. Therefore, either front or back side insertion will charge
the transmitter accordingly.

Battery Charger Indicators:

Battery Charger Troubleshooting:

! Use the attached MIPRO 12V/500mA DC power adapter to avoid insufficient current,

voltage irregularity or damaging the equipment.

! Ensure the transmitter is fully charged before and after use.

! Ensure the transmitter is turned off before placing into the battery charger.

! Check the battery contacts for corrosion or wear. Clean the contacts with dry cloth only.

Water or chemicals can damage the contacts.

! For potential risks and dangers always use the attached MIPRO battery charger only for

charging. Do not place the transmitter in any other unauthorized battery chargers.

! The battery has a limited life. The amount of play time will decrease as the battery

ages or after many recharge cycles. The battery needs to be replaced when play time
becomes too short or when it can no longer be charged.

! Do not place the transmitter into the charger if there is visible battery leakage. Replace

with a new transmitter.

Red Indicator (illuminate): Charging in progress.

Green Indicator (illuminate): Fully charged. A fast charge takes approx. 3 hours
then continuous trickle charges.

Charging Indicators

a

b

!

!

!

!

!

!

!

Only a few hours of operation after a fully-charged.

No longer holding a charge. (no battery voltage).

Short operating distance after a fully-charged.

Power indicator does not illuminate when pressed.

After 1 or 2 years depending how often it is used. Battery life is determined by
temperature, depth and rate of discharge, and the number of charges and discharges
(called cycles).

Excessive wear and tear.

Extreme weather conditions.

If a new battery replacement is needed, open the battery compartment by removing the
two screws. Insert two rechargeable batteries or disposable alkaline batteries into the
battery compartment with correct polarity placement.

When to Replace the Rechargeable Batteries:

How to Change a Battery:

Rechargeable Multi-function Transmitter

Rechargeable Multi-function Transmitter

a

b

Advertising
This manual is related to the following products: