MIPRO ACT-101 IR Remote-Controlled Single-Channel Diversity Receiver - Manual (Page 9)

! Ensure it is plugged into an AC outlet.
! Ensure MT-101ACT transmitter microphone is fully charged.
! Aim the bottom of transmitter towards the ACT Port ( or ) .
! Press and hold the ACT button on the transmitter for at least 1 second to power on.
! Still red ACT Port Indicator Switch or Power Indicator denotes the power is on.
! ACT Port Indicator Switch or Power Indicator illuminates and dims denotes the
power is not turned on successfully. Repeat above steps until still red indicator
illuminates.
! Flashing ACT Port Indicator Switch or Power Indicator 4~5 times denotes
incorrect receiver and transmitter frequency band used.
! Once ACT Port Indicator Switch or Power Indicator illuminates red, transmitter
microphone is now ready to be turned on.
! Ensure MT-101ACT transmitter microphone is fully-charged.
! Turn on the Transmitter Power Switch .
! Speak into the microphone directly for amplification.
! Normal or Fully Charged Battery:
Red indicator illuminates and dims when Transmitter Power Switch is turned on.
! Low Power Battery:
Red indicator stays illuminate when Transmitter Power Switch is turned on.
! Drained Battery:
Red indicator does not illuminate when Transmitter Power Switch is turned on.
No Battery Inside or Battery Installed Incorrectly:
Red indicator does not illuminate when Transmitter Power Switch is turned on.
Wireless IR Remote Control Receiver Wireless IR Remote Control Receiver
OPERATING INSTRUCTIONS
To Power ON ACT-101/ACT-101i Receiver:
To Power ON MT-101ACT Transmitter Microphone:
MT-101ACT Transmitter Microphone Battery Status:
! Aim the bottom of transmitter towards the ACT Port ( or ).
! Press and hold the ACT button on the transmitter for at least 1 second to power off.
! A dim ACT Port Indicator Switch or Power Indicator denotes the power is off.
! DO NOT touch the ACT Port Indicator Switch once is powered off.
! Each receiver and transmitter has an attached coded frequency label.
! Ensure that both the transmitter and receiver are operating on the same frequency
band in order to power on & off both receiver and transmitter.
! A flashing 4~5 indicator denote incorrect receiver and transmitter frequency band was
used.
! MIPRO's innovative design allows the versatile transmitter to sync any receiver
frequency within the same frequency band.
To Power OFF ACT-101/ACT-101i Receiver:
Different Transmitter and Receivers Frequency Bands:
2
2
18
18
14
14
1
1
1
1
1
1
25
25
25
25
25
13
13
13
13
13
12 13