MIPRO ACT-32TC Rechargeable Bodypack Transmitter - Manual (Page 10)

Battery Removal and Installation
! Pushing down both snap locks on the sides to
open battery compartment cover. Take out the
two batteries. (Figure 3)
!
Insert one charged 18500 rechargeable battery
into the battery compartment according to the
correct polarity (- and +) as shown in (Figure 4)
. Then close the battery compartment cover
tightly.
Caution
Remove the batteries if unused for a long period of
time to prevent battery leakage, corrosion and
causes possible damage to electronics.
(Figure 4) (Figure 3)
16 17
Caution
Note: Transmitter cannot be powered on with
charged battery.
Method 1:
a. Ensure battery is inserted correctly with + top
side.
b. If battery is inserted correctly it could be due
to self battery protection mechanism. Insert the
transmitter into the charger to re-charge for
10-20 seconds to wake-up the battery. It
should work.
c. If charger cannot be used, reverse the battery
insertion for 10-20 seconds, wake up the
battery with correct polarity. It should work.
Method 2:
a. Power off the transmitter before open the
hinged cover. Press battery protection circuitry
reset button once to wake-up battery. Power on
the transmitter.
ON MODE SET
Battery Protection
Circuitry Reset Button
Rechargeable Bodypack Transmitter Rechargeable Bodypack Transmitter