MIPRO ACT-32TC Rechargeable Bodypack Transmitter - Manual (Page 8)

ERR Message
! When “ERR” appears in the display it indicates
that an operational error has occurred. Please
refer to the following codes to diagnose which
error you are experiencing.
ERR no01 EEPROM is not being programmed or
internal data error.
ERR no02 For testing only.
ERR no03 The frequency you want to program is
above the switching bandwidth of the
transmitter. Use a receiver with an
appropriate frequency group. (At this time
the microphone is still operating and the
frequency remains unchanged. To clear the
displayed "ERR" message, switch the
handheld transmitter off and on again.)
ERR no04 The frequency you want to program is
below the switching bandwidth of the
transmitter. Use a receiver with an
appropriate frequency group. (At this time
the microphone is still operating and the
frequency remains unchanged. To clear the
displayed “ERR” message, switch the
handheld transmitter off and on again.)
! “Group” & “Channel” : When both the group
and channel numbers are displayed, it means
that you are using the pre-programmed
frequency of the receiver.
! “Channel” Only : If “Channel” only is
displayed, it means that you are using a
frequency which is not pre-programmed.
12 13
MUTE
AF MUTE
AF INPUT
Setting MUTE
! Press MUTE button to enter MUTE mode.
! Under MUTE mode, press MUTE button to exit
MUTE mode.
! MUTE button is operable when SET LOCK mode
is LOCK.
! MUTE button is operable when MUTE MODE is
set in MANUAL mode.
AF MUTE AF MUTE
MANUAL
MUTE MODE
MODE MODE MODE
E F
AF MUTE
RF-LOW
RF POWER
D
AF MUTE AF MUTE
775.275
MHz
FREQUENCY
0 dB
AF GAIN
MODE MODE MODE
A B C
UNLOCK
SET LOCK
AF MUTE
01 01
GRP CH
Rechargeable Bodypack Transmitter Rechargeable Bodypack Transmitter