Pathway #48xx Installation Repeaters Operation and Maintenance Guide - Manual

MAINTENANCE
OPERATING ENVIRONMENT
This guide covers the following Pathway product
numbers:
#4807 - 4-way Installation Repeater
#4808 - 8-way Installation Repeater
#4809 - 12-way Installation Repeater
#4810 - 16-way Installation Repeater
#4813 - 4-way Installation Repeater w/RDM
#4814 - 8-way Installation Repeater w/RDM
#4815 - 12-way Installation Repeater w/RDM
Pathway eDIN Installation Repeaters are in-
tended for installation in dry, indoor, non-
hazardous environments suitable for NEMA 1
enclosures.
Operating temperature range is from –10°C to
+60°C, up to 95% humidity, non-condensing.
OPERATION
Installation Repeater—Operation and Maintenance
Model 4808
Pathway eDIN Installation Repeaters require
very little maintenance. Enclosures exteriors
should be inspected annually for physical dam-
age from impacts or liquids. Steps should be
taken, if necessary, to prevent liquids from con-
tacting the enclosure in future.
Enclosure interiors should be inspected
annually for loose wires and connections, and
for debris. Connections should only be tight-
ened if necessary. Debris should be gently re-
moved from the interior and its source deter-
mined.
WARNING
All DMX input/output ports must be connected
to low-voltage data lines only. Do not connect
high voltage sources to these connectors or
serious damage and possible injury will occur.
Once a Pathway eDIN Installation Repeater is
completely and properly installed, its operation
is fully transparent to the end user. No on-going
or periodic user action is required.
In the event of power loss, an eDIN Installation
Repeater will resume full normal operations
once power is restored, without any user action
or intervention necessary.
Pathway Connectivity Solutions
#103 - 1439 17 Avenue SE Calgary AB Canada T2G 1J9
(403) 243-8110 fax (403) 287-1281
[email protected]
www.pathwayconnect.com
All Pathway eDIN Installation Repeaters shall
carry a two-year Limited Warranty against de-
fects in materials and workmanship under nor-
mal use and service. Pathway Connectivity’s
sole responsibility under this warranty shall be
to repair, replace or refund at Pathway’s discre-
tion, any units which are determined to be de-
fective upon Pathway’s inspection. Pathway
may elect to refund the cost of the device upon
return, solely at Pathway Connectivity’s discre-
tion. This warranty applies to the original pur-
chaser or retail customer only
WARRANTY