Myron L 6PFCE and 4P User Manual
Page 48
There is a ratio of TDS to compensated conductivity for any solution,
which varies with concentration. The ratio is set during calibration in User
mode as in User Programmable Conductivity to TDS Ratio, pg. 16.
A truly unknown solution has to have its TDS determined by evaporation
and weighing. Then the solution whose TDS is now known can be
measured for conductivity and the ratio calculated. Next time the same
solution is to be measured, the ratio is known.
XXIII. ph and ORP (6PFC
E
)
A. pH (6PFC
E
)
1. pH as an Indicator (6PFC
E
)
pH is the measurement of Acidity or Alkalinity of an aqueous solution. It
is also stated as the Hydrogen Ion activity of a solution. pH measures
the effective, not the total, acidity of a solution.
A 4% solution of acetic acid (pH 4, vinegar) can be quite palatable, but
a 4% solution of sulfuric acid (pH 0) is a violent poison. pH provides the
needed quantitative information by expressing the degree of activity of
an acid or base.
In a solution of one known component, pH will indicate concentration
indirectly. However, very dilute solutions may be very slow reading, just
because the very few ions take time to accumulate.
2. pH Units (6PFC
E
)
The acidity or alkalinity of a solution is a measurement of the relative
availabilities of hydrogen (H
+
) and hydroxide (OH
-
) ions. An increase
in (H
+
) ions increases acidity, while an increase in (OH
-
) ions increases
alkalinity. The total concentration of ions is fixed as a characteristic
of water, and balance would be 10
-
7
mol/liter (H
+
) and (OH
-
) ions in a
neutral solution (where pH sensors give 0 voltage).
pH is defined as the negative logarithm of hydrogen ion concentration.
Where (H
+
) concentration falls below 10
-7
, solutions are less acidic than
neutral, and therefore are alkaline. A concentration of 10
-9
mol/liter of
(H
+
) would have 100 times less (H
+
) ions than (OH
-
) ions and be called
an alkaline solution of pH 9.
3. The pH Sensor (6PFC
E
)
The active part of the pH sensor is a thin glass surface that is selectively
receptive to hydrogen ions. Available hydrogen ions in a solution will
accumulate on this surface and a charge will build up across the glass
interface. The voltage can be measured with a very high impedance
voltmeter circuit; the dilemma is how to connect the voltmeter to solution
on each side.
The glass surface encloses a captured solution of potassium chloride
holding an electrode of silver wire coated with silver chloride. This is
the most inert connection possible from a metal to an electrolyte. It can
44