Team Associated RC10 - Manual (Page 17)

17
:: Wheels / Tires and Body - Bag J - Step 3
:: Wheels / Tires and Body - Bag J - Step 4
:: Wheels / Tires and Body - Bag J - Step 5
Painting Tips:
Body and Wing:
Your RC10 Worlds Kit comes with a clear polycarbonate
body and wing. You will need to prep the body and wing
before you can paint them. Wash the inside thoroughly
with warm water and liquid detergent. Dry the body and
wing using a clean, soft, lint-free cloth. Install the window
masks on the inside of the body. (RC cars get painted
from the inside). Using high quality masking tape, apply
tape to the inside of the body to create a design. Spray
(either rattle can or airbrush R/C specific paint) the paint
to the inside of the body (prefferably dark colors first,
lighter colors last).
NOTE: use ONLY paint that is recommended for use with
(polycarbonate) plastics. If you do not, you can
destroy the plastic body and wing!!!!).
After painting, cut the body and wing along the trim lines.
Make sure to drill or use a body reamer to make the
holes for the body mounts, wing mounts, and antenna!
x2
6952
8-32 Steel
Locknut
6222
4-40/5-40
Nylon Locknut,
black
3977
Bearing,
3/16” X 3/8”
x2
Build left and
right sides!
Build left and
right sides!
6332
Body
clip
6182
Wing,
clear
x2 x2 6189
Wing
mounts
4436
4-40 x 5/16”
Set Screw
6189
Wing mount
wire
TIP: Bending the
wire as shown can
help ensure the wing
buttons are parallel.
TIP: Bend wire to
create tight fit inside
wing tubes.
! !