Magikitch'n MKG Gas Griddle - 24" Deep - Manual (Page 11)

Operations
MKG Series Gas Griddle
L25-055 Rev. 0 (05/12) 11
2. Operation
Ensure that a proper installation has been performed on the appliance and that all warnings, cautions, and
notices contained in this manual have been read, understood and adhered to before proceeding.
2.1. Lighting Instructions
2.1.1. Snap-Action Thermostat Appliances
1. Turn all thermostat knobs to the “OFF”
position.
2. Open front door of the griddle, turn the
manual gas shut off valve to the “ON”
position, see Figure 6.
3. Press and hold the left or right RED
pilot button, see detail Method A at right,
and light the left or right pilot by depressing
the Piezo ignition control, look through the
pilot hole to see the pilot ignites. With pilot
burning, keep the RED pilot knob
depressed for 45 seconds or until pilot
remains lit automatically. If the Piezo
ignition control does not light the pilot(s), a
flame source can be used to light the
pilot(s) through the pilot holes provided in the front panel of the appliance.
4. Repeat steps 1,2, and 3 for all remaining pilots.
5. Operate thermostats by turning knobs clockwise to the desired temperature and insure that burners light
properly by looking through the pilot holes provided in the front panel.
2.1.2. Solid State and Electric Thermostat Appliance
1. Turn all thermostat knobs to the “OFF” position, or the lowest possible temperature setting.
2. Turn the Manual gas shut off valve to the "ON" position, this valve is located at the rear of the unit, see
Figure 6a. To open the valve to allow gas flow the handle should be in line with the manual shut off valve.
3. Turn the RED "I/O" switch to the “ I ” (ON) position for all desired Thermostats to be operated, See Figure
7. When the Pilot ready (Yellow) light illuminates, the pilot(s) are ready to operate the main burners.
4. Repeat steps 1,2, and 3 for all thermostat controls to be operated.
5. Operate thermostats by turning knobs clockwise to the desired temperature and insure that burners light
properly by looking through the pilot viewports provided in the front panel. The RED "I/O" switch will
illuminate when the thermostat calls for heat.
Figure 7
LEFT PIEZO IGNITOR RIGHT PIEZO IGNITOR
LEFT PILOT BUTTON RIGHT PILOT BUTTON
PILOT HOLES