Magikitch'n NPG-60 - Manual (Page 5)

L25-011 Rev 1 (05/11)
3
2. CHARBROILER ASSEMBLY INSTRUCTIONS
These unassembled parts should be included in your charbroiler package, (Figure 1, Page 5):
Item Number Description
1 Cooking Grid (s)
2 Radiants Burner Covers
6 Frame Assembly
8 Runner Tube Cover(s)
9 Water Tub(s)
10 Base
24 Legs and Swivel Lock Casters
C Main Valve and Regulator Assembly
A. Remove shipping bands from carton.
B. Remove top of carton.
C. Remove cooking grids(s), (1) from unit and set aside.
D. Remove and unwrap any small parts packages that are located inside beneath the cooking grid. NOTE:
Parts made of stainless steel may be coated with a protective plastic film that must be removed before
firing.
E. Lift frame assembly (6) from carton and set aside.
F. Lift water tub(s) (9) from carton and set aside.
G. Lift base (10) from carton and place upside down on ground.
H. To install the leg & caster assemblies, insert the assemblies (24) into the leg sockets on the base (10)
and depress “snap button” on leg. The leg will slide into the socket and will lock into the correct location.
I. Flip the base over, with the leg & caster assemblies installed, into the upright position. Place the frame
assembly (6) on base (10) with the shelf support brackets located in the notches on the front base
assembly.
J. Attach the anchoring means from the unit base to the building structure (See Installation Instructions on
page 4).
K. Place runner tube cover(s) (8) on their brackets to cover the runner tube(s).
L. Place the radiants (2) on their front and rear support pins over each burner.
M. Slide water tub(s) (9) into frame assembly (6).
N. Place cooking grid(s) (1) into frame assembly (6).