Magikitch'n NPG-60 - Manual (Page 8)

L25-011 Rev 1 (05/11)
6
5.
OPERATION, LIGHTING and CLEANING
(Use Figure 2)
• Assemble unit per installation/assembly instructions.
• Fill water tubs to within ½” of top edges (this will control grease flare-ups, provide for ease of cleaning and keep
cooked foods moist). Re-fill tubs with water when they evaporate to within ½” of the bottom of the tubs. Failure
to keep water in the water tubs will lead to grease fires and will void the warranty.
Lighting Instructions
A. Open the cooking hood, if so equipped. Turn the main gas valve (red knob on the left side) and all the burner
knobs clockwise to the ‘off’ position.
B. Open the main gas valve and insert a lit match with the matchstick holder or a gas grill lighter flame through the
oblong hole in the front panel.
C. Check that the entire runner tube is lit by looking through the sight hole(s) located between the end burner
knobs on the front panel. If the runner tube(s) will not light or stay lit, shut off the gas supply and do not use the
unit. Wait 5 minutes before attempting to re-light the unit.
D. After lighting the runner tube(s), open the desired burner valves and observe that the burners light completely
from the runner tubes(s).
Warning: If the runner tube(s) or burners fail to light or remain lit, shut off the gas supply and discontinue use of the
unit. Call for service to correct the problem.
Shutdown Instructions
• To shut down the unit, turn the main gas valve (red knob on the left side) clockwise to ‘off’, and then close all
the burner valves.
Figure 2
Cleaning the Unit
• Clean the unit regularly after use.
• Cooking Top Grid:
After removing from the unit, use warm soapy water and a stiff bristled brush or
plastic pad. Cooking grid (top grid) must be removed to steam clean or pressure wash. Do not use steel
wool or abrasive pads as they may degrade the metal finish.
• Radiants/Covers: These will need little or no cleaning due to high in-use temperatures. If necessary,
clean as for the cooking grid.
• Frame Assembly: Use warm, soapy water and a stiff bristle brush or plastic pad. Be careful not to
get water into the burners or runner tubes. Do not pressure wash.
• Water Tubs/Base Assembly: Clean as per top grid.