Minka Group F702-VB - Manual (Page 7)

5.H
ANGING THE
F
AN
REMEMBER to turn off the power.
Follow the steps below to hang your
fan properly:
Step 1. Secure the hanger bracket to
the ceiling outlet box using screws
included with your outlet box, lock
washers included with the fan. (Fig.8)
Step 2. Loosen the two set screws and
remove the hitch pin and lock pin in
the top coupling of the motor
assembly. (Fig. 9)
Step 3. Remove hanger ball from
downrod assembly by loosening set
screw, removing the cross pin, and
sliding ball off rod. (Fig.10)
Step 4. Carefully feed fan wires up
through the downrod. (Fig. 11)
Thread the rod into the coupling,
next line up holes and replace lock
pin and hitch pin. Tighten set screws.
Step 5. Slip coupling cover, canopy
cover and canopy onto downrod.
(Fig. 12) Carefully reinstall hanger
ball onto rod being sure that cross pin
is in correct position, set screws are
tighten and wires are not twisted.
Step 6. Now lift motor assembly
into position and place hanger ball
into hanger bracket. Rotate until the
check groove has dropped into the
registration slot and seats firmly. (Fig.
13) Rod should not rotate if this is
done correctly.
Outlet box
Hanger bracket
Downrod
Supply
wires
Figure 8
Figure 10 Figure 11
Figure 9
Figure 12
Figure 13
Downrod
Coupling
*Omit coupling
cover when
downrod
cover
using
the minimum-length
Canopy
Canopy cover
Set screws
Hitch pin Lock pin
Registration
slot
Cross pin
Hanger
ball
Downrod
Hitch
pin
Lock
pin
Set
screws
Screw