Minka Group F702-VB - Manual (Page 8)

E
LECTRICAL
C
ONNECTIONS
6.
WARNING: To avoid possible electrical
shock, be sure electricity is turned off at
the main fuse box before wiring.
NOTE: (Fig. 14) This remote control
unit is equipped with 16 code
combinations to prevent possible
interference from or to other remote
units. The frequency switches on your
receiver and wall transmitter have been
pre-set from the factory. Please recheck
to make sure the switches from both
units are set to the same positions. Any
combination of settings will operate the
fan as long as the wall transmitter and
receiver are set to the same switch
settings.
Step 1. (Fig.15) Insert the receiver unit
into the hanger bracket with the flat
side of the receiver facing the ceiling.
Step 2. (Fig. 16 & 17) Motor to receiver
electrical connections; Connect the black
wire from the fan to the black wire
marked "To motor L" from the receiver.
Connect the white wire from the fan to
the white wire marked "To motor N"
from the receiver. Connect the blue wire
from the fan to the blue wire marked
"For bottom light" from the receiver.
Connect the orange wire from the fan to
the orange wire marked "For Upper-
light" from the receiver.
Step 3.(Fig. 16 & 17) Receiver to house
supply wires electrical connections;
Connect the black (Hot) wire from the
outlet box to the black wire marked "AC
in L" from the receiver. Connect the
white (neutral) wire from the outlet box
to the white wire marked "AC in N"
from the receiver. Secure all wire
connections with the plastic wire nuts
provided.
Step 4. (Fig. 16 & 17) If your outlet box has
a ground wire (green or bare copper) connect
the fan ground wire from hanger ball and
hanger bracket to it; otherwise connect the
fan ground wire from the hanger ball and
hanger bracket together.
Step 5. After the splices are made, secure
connectors with electrical tape. Spread the
wires apart so that the green and white wires
are on one side of the outlet box and the
black, orange and blue wires are on the other.
Make sure there are no loose strands or
connections. Turn wire connectors upward
and push the wiring into the outlet box.
Fig. 14
Fig. 15
Receiver
Hanger bracket