Martin Universal Design U-DS1776R - Liberty Drawing Table - Manual (Page 5)

Assembly
Since 1853
STEP 3
This step involves attaching the Modesty
Panel (part 5) to the table base.
To do so you must use 2 ea. Cam Locks
(part L). Insert the cam locks in the rear
side of the Modesty Panel by placing them
into the pre-drilled holes that can be found
near each of the 4 corners. Make sure the
Phillips screwdriver head is facing out of the
modestly panel holes.
Continue by lining up the holes in the ends
of the Modesty Panel with the holes in the
side of the base legs. Secure to base using
2 ea. bolts (part F). Tighten down bolts, while
holding Cam Locks (part L) with screwdriver
so they do not move. See FIG 3.
Repeat with other end of Modesty Panel to
complete assembly of Step 3.
FIG 3
Zoom of
Modesty Panel
attachment
STEP 4
Attaching Shelf (part 6) to base.
To do so you must use 2 ea. Cam Locks
(part L). Insert the cam locks into the holes
found on the bottom of the shelf. You will
need to hold these in place with your finger.
Continue, by lining up the holes in the edge
of the shelf with the holes in the base legs.
Secure to base using 2 ea. bolts (part F).
Tighten down bolts, while holding Cam
Locks (part L) with screwdriver so they do
not move. See FIG 3.
Repeat with other end of Shelf to complete
assembly of Step 4.
FIG 4
5
5
F
L
Zoom of
Shelf attachment
F
F
6
L
August 08, RPI