Martin Universal Design U-DS1776R - Liberty Drawing Table - Manual (Page 7)

Assembly
Since 1853
N
STEP 8
Attaching Base to Top
To attach the Base to the top, you will need
to position the end of the top rail of each
base leg into the Base Bracket (part N) as
indicated in the Zoom portion of FIG 8.
After positioning it properly secure it in place
using 1 ea. Bolt (part E) and 1 ea. Nut
(part H). Tighten down to secure. Repeat
with second bracket on other end of table.
FIG 8
Zoom of
attachment
STEP 9
Attaching Tilt Mechanism to Top Bracket
To attach the Tilt Mechanism (part O) to the
top bracket, you will need to position the
end of the tilt mechanism into place on the
bracket. After positioning it properly secure
it in place by inserting 1 ea. Bolt
(part D) through the mechanism then place a
washer (part G) over the bolt end, continue
going through the bracket (part M) and
complete with 1 ea. Capped Nut (part I).
Tighten to secure.
See FIG 8 for a detailed image.
FIG 9
Zoom of
attachment
E
H
D
I
O G
M
August 08, RPI