Martin Universal Design 92-3010 Weber Monster Amalfi Studio Easel - Manual (Page 3)

Page 3
FIG 8c
STEP 6. Attach Material Tray (5) to Channelled Center
Column (4) using four 4 X 25mm Screws (D).
See FIG 6a & FIG 6b.
STEP 8a. Assembling the H-Frame. This step involves
assembling parts (6, 7, 8 & 9) to form the H-Frame
portion of the easel. Begin by taking the channelled
sides (6) & the upper cross member (9) and inserting
the oval male ends of the upper cross member into the
oval holes of the channelled sides. See FIG 8a.
Secure this step using two 6 X 60mm bolts and Cams
as previously described in earlier steps. (as in Step 3)
5
FIG 6a
FIG 6b
STEP 7. Attach Loop Mechanism (E) to Material Tray
(5) using the four 3 X 12mm screws. Secure with
Phillips Screwdriver (provided) See FIG 7.
NOTE: Make sure the Loop Mechanism is in the
proper position as shown in FIG 7. This will allow
for proper adjustments when moving the material
tray up or down the Ratchet Column.
FIG 7
4
5
4
5
4
E
6
9
6
FIG 8a
Make sure the Ratchet column
is positioned so that the metal
part that is closest to one end
of the column is the bottom
end. See FIG 8c.
NOTE: This column is secure
once the bottom portion of
the H-Frame is assembled.
NOTE: This image
is the rear side of
the H-Frame. The
metal portion of
the ratchet
column is on the
reverse side. Not
visable in this
photo.
FIG 8b
Bottom End
of Ratchet
Column
connects with
lower cross
member (8)
Top Portion of
Ratchet
Column
connects with
upper cross
member (9)
STEP 8b. Continue by
inserting the ratchet
column (7) up into the
oval hole of the upper
cross member (9).
9
7
7