Martin Universal Design 92-3010 Weber Monster Amalfi Studio Easel - Manual (Page 6)

Martin/F. Weber Co. • 4444 Lawton Avenue, Detroit, MI 48208 USA
Tel:(313)895-0700 • Fax:(313)895-0709 • E-mail:[email protected]
www.MartinUniversalDesign.com • www.weberart.com • Made in China
Created NOV07RPI
IMPORTANT
If you have difficulty assembling your 92-3010 Weber Monster
Amalfi Studio Easel or need customer service assistance.
Please call: Martin Universal Design, Inc. Customer Service Hot
Line at 1-313-895-0700. If you need additional parts,
it is not necessary to contact your dealer, our Customer Service
Rep. will forward them to you immediately.
Page 6
STEP 18. Once Channelled Center Column is in its
proper location in the upper Cross Support, secure with
the longest of the three remaining knobs by threading the
threads of the knob in the hole in the rear of the cross
support. Tighten to secure. See FIG 18.
STEP 20. Final step involved in the assembly of your
New 92-3010 Easel.
Attach the Upper Canvas Support (13) to the Adjustable
Center Column (12) by sliding the grooves of the canvas
support down into the channels of the Adjustable Center
Column. Do this from the top end of the Adjustable
Center Column. Secure with remain knob. tighten to
secure at desired position. See FIG 20
FIG 18
STEP 19. This step involves adding the Adjustable
Center Column (12) down into the Channelled Center
Column (4). See FIG 19. To secure into place, thread one
of the remaining two shorter knobs into the hole found on
the rear of the Channelled Center Column. See FIG 19b.
FIG 19
FIG 19b
Rear view of
Channelled Center
Column where knob
is to be threaded.
4
9
13
7
12
4
12
4
FIG 20
ADJ 1. Adjusting Height Material Tray.
Insert finger in locking loop pin below Material Tray and
pull outward. This will cause the material tray support to
release from the metal ratchet column allowing you to
raise or lower the material tray and center column.
PLEASE NOTE: Be careful when raising the
material tray, that you are aware that the top of the
column will not interfere with ceiling or any other
object in rooms that have low ceilings.