Martin Universal Design 92-3010 Weber Monster Amalfi Studio Easel - Manual (Page 5)

Page 5
STEP 14. Attach Extendable Rear Legs (10&11) to base
(1) and upper portion of Channelled Sides (6).
Attach the wider end of the adjustable Rear legs (10) to
the base by securing with one 5 X 25mm Screw.
See FIG 14 for proper location. Secure with Phillips
screwdriver. Repeat with other Extendable Leg.
11
6
FIG 14
FIG 15
H3
H3
STEP 15. Attach upper portion of Extendable Rear Legs
(11) to upper portion of Channelled Sides (6).
Pull-out the narrower end of the extendable leg (11) and
attach it to the inside edge of the channelled sides by
inserting one 6 X 45mm bolt (H3) through the outside side
of the channelled side continuing through the extendable
leg (11) and then placing the metal washer over the bolt
and tightening with the knob to secure. See FIG 15.
See FIG 15b for proper view of assembly step 15.
FIG 15b
6
6
11
11
7
9
STEP 16. Attach 6 X 40mm Bolts, knobs & washers (H4)
to Extendable legs (10 & 11). These adjustment knobs
are used along with the others to lower the easel into a
horizontal position. Insert the bolt through the inside edge
of the extendable
leg (11), continue
going though to the
other side and
complete with metal
washer and knob.
Tighten to secure.
See FIG 16.
FIG 16
STEP 17. Loosen all knobs to lower the easel into the
horizontal position. Once in flat position, tighten all knobs
to secure. See FIG 17. This step involves inserting and
sliding the Channelled Center Column (4) and Material
tray (5) assembly through the upper cross member (indi-
cated by the circle) and guiding the material tray corners
into the channelled Sides (indicated by the squares). See
FIG 17. See inset photos below for detail.
FIG 17