Wildgame Innovations PD1 - Manual (Page 3)

Programming
Setting Time:
1.Press the ▲ button, or Program button from
“READY” mode to enter the “CLOCK” mode. Press the
Program button again to enter the clock settings. Use
the + or - buttons to set the desired hour, then press
the Program button and use the + or - buttons to adjust
minutes. After the time is set, wait for 10 seconds for
the unit to go back to “READY” mode automatically. New Timer
Installation (cont.)
Connect to Battery:
1.The PD1 timer is designed to be ran by a 6 or 12 volt
battery. We recommend a rechargeable type 6 or 12
volt battery.
2.Start by installing the Red wire from the timer unit to
the Positive (+) battery terminal.
3.Next, install the Black wire from the timer unit to the
Negative (-) battery terminal.
4.Once the battery is hooked up correctly, the voltage
verification icon will appear on the LCD.