Avaya P117F(R) - Manual (Page 41)

Chapter 3 Configuration
14 (11) – Set ATM Port Parameters to their Default Values
This option returns the ATM port parameters to their default values.
ATM port default values:
UNI Version : 3.1
Physical Media : SONET
ATM Address : Using ILMI
LECS ATM Address : Using ILMI/WKA/PVC
ELAN Configuration : default ELAN
Default Redundancy Mode: ENABLE
Default Active ATM Port: UPPER
*** Set ATM port to default values ***
15 (12) – Set Ethernet Port Parameters to their default values
This option returns Ethernet port parameters such as VLAN number and enable
status to their default values. It does not affect agent access parameters such as IP
addresses, IP Routes, and Permanent Managers. It does not set the ATM port
parameters to their default values.
Use this option if, for example in using device management, you accidentally
disabled the port to which the management station is connected. If you disable the
Ethernet port to which the management station is connected you will no longer be
able to contact the P117F(R) from the device manager.
>>>Enter your choice:
***WARNING*** Port parameters were changed. Reset the agent!!!
>>>PRESS Enter to continue:
P117F(R) Stackable Switch Installation Guide 39