Australian Monitor AMC+MIX - Manual (Page 5)

1 2 3 6 4 5
1 CH 1–4
Each channel input section has two inputs: XLR input – This is a balanced
microphone input. It has an input sensitivity of 1mV. RCA input – This is an
unbalanced line level input. It has an input sensitivity of 150mV. The two RCA
sockets are summed to mono internally.
2 REC Output
The REC output is on unbalanced RCA connectors. The output level is 150mV
into 10kohm at rated output. The output is dual mono.
The REC output is not affected by the MASTER volume control or the BASS and
TREBLE controls.
The REC output does not receive the tone signal if the optional tone generator
module is installed.
3 Line Output
The LINE output is on a balanced XLR connector. The output level is 1V into 1k
at rated output.
NOTE: When wiring the LINE output as unbalanced, Pin2 should be wired as
hot and Pin1 should be wired as ground/shield. Do not wire Pin3.
4 (Optional) Tone Module
These terminals are for use with an optional tone module (not supplied).
Use Australian Monitor ATC5488 module.
5 AC Power Socket
This is a 5.5mm x 2.1mm barrel socket. It accepts 20V AC power from the plug
pack provided.
6 Phantom Power
12V phantom power is available for condenser or electret microphones on the
XLR input when this switch is pushed in.
PAGE 5 AMC + MIX INSTALLATION AND OPERATION MANUAL
REAR PANEL