Australian Monitor AMC+MIX - Manual (Page 6)

Mounting
Your amplifier is designed for standard 19” rack mounting and occupies 2 EIA
rackunits (3.5”).
The mounting centres are:
Vertical: 1.5” (38.1mm) Horizontal: 18.2” (461.2mm) to 18.7” (473.8mm)
The slots in the mounting flange will accept bolt diameters up to 1/4”
(6.35mm). We recommend that you provide additional support for the amplifier,
especially if road use is planned, as the weight could bend some rack frames.
This support can be provided by secure shelving on support rails.
Montage
Cet ampli convient pour un montage en rack de 19” et a 2 unités de 3.5”.
Les centres de montage sont:
Vertical: 1.5” soit 38.1.2 mm Horizontal: de 18.2” (soit 461.2mm) à 18.7”
(soit 473.8 mm).
Vous pouvez mettre des vis de 6.5 mm maximum dans ls fentes de la bride de
montage. Nous vous recommandons un support supplémentaire car le poids
peut parfois faire plier le chassis en cas d’usage intensif.
OUTPUT CONNECTIONS
Line Output
The LINE output XLR can be used to connect up to 6 booster amplifiers.
Balanced wiring (shielded pair cable) is recommended.
NOTE: When wiring the LINE output as unbalanced, Pin2 should be wired as hot
and Pin1 should be wired as ground/shield. Do not wire Pin3.
Rec Output
The TAPE output wiring should be kept as short as possible. Typically less
than 3m.
Input Connections
For wiring balanced in, pin 2 is hot. Unbalanced wiring on the microphone
inputs is not recommended. Balanced input wiring (shielded pair cable)
is recommended.
Unbalanced RCA wiring should be keep as short as possible. Typically less
than 3m.
PAGE 6 AMC + MIX INSTALLATION AND OPERATION MANUAL
INSTALLATION