Rivera Primo Brute V - Manual (Page 6)

16
17
18
DO NOT OPERATE
this or any other Rivera Primo Inc. open-primary belt-drive without the proper safety guard or belt cover in place. A well designed
belt guard actually adds to the appearance of the motorcycle while protecting you as well as the belt drive from incidental
damage caused by rocks or debris between the belt and the pulleys. Be safe, always use a belt guard!
Y O U R A T T E N T I O N P L E A S E ! !
STEP 16:
TIGHTEN THE SHOULDERED NUTS
EQUALLY UNTIL THEY BOTTOM, AND
THEN TIGHTEN TO 30 INCH POUNDS
(NOT FOOT POUNDS) OF TORQUE.
Install the clutch adjustment screw &
adjust the clutch. Bend the lock tabs over
to prevent the shouldered nuts from
coming loose.
Note: Never use Loctite on these threads
STEP 17:
Install the starter support housing (over the starter extender
mechanism) as pictured. Carefully locate the housing to align
the bolts. Check to make sure the starter can turn freely as the
bolts are tightened.
TORQUE THE BOLTS TO 29 FOOT POUNDS.
STEP 18:
This is what your installation should
look like. To insure your safety guards
must be used or serious injury may
occur. Be sure & install either the belt
guard that came with the kit, or one of
Rivera Primo Inc.’s optional belt
guards. To check belt tension grasp the
top belt & move up and down. It should
have approximately 3/4” of total move-
ment with a cold drive train.
A belt guard is included with all BRUTE V TM kits. Bolt it to the
stand-off studs using the supplied 5/16” buttonheads &
TORQUE TO 29 FOOT POUNDS.
18A
6