Rivera Primo Brute V - Manual (Page 8)

RIVERA PRIMO Inc. 12450 Whittier Blvd, WHITTIER, CA 90602
(562) 907-2600 FAX (562) 907-2606 E-mail: [email protected]
www.riveraprimoinc.com
CLUTCH ASSEMBLY - BRUTE V
TM
/ 3-1/2” WIDE / 14 mm BELT
IMPORTANT INFORMATION
DO NOT OPERATE this or any other Rivera Primo Inc. open primary belt drive without the proper safety guard or belt cover
in place. A stamped billet aluminum safety guard has been supplied with this belt drive kit. Install the supplied guard or suit-
able other guards and/or belt covers available from Rivera Primo Inc. prior to starting the motorcycle.
ADEQUATE GROUND CLEARANCE is extremely important, especially when turning to the left. Once installed, make certain
the belt drive assembly does not in any way interfere with this turning geometry. Should there appear to be a problem, correct
it immediately so as to provide adequate & safe ground clearance. DO NOT OPERATE the motorcycle until this is done!
LIMITED WARRANTY:
All pulleys are warranted to be free from defects in material and workmanship under normal use for a period of one year from
actual date of purchase. Seller’s liability shall be limited to repair or replacement of any materials found to be defective, free
of charge at it’s plant or authorized service depots, of specific manufactures components. It is further warranted that products
that were designed for a specific purpose, shall perform for that purpose when installed exactly as defined in the Installation
Instructions accompanying the unit. In no event shall Rivera Primo Inc. or seller be liable for consequential or special dam-
ages asserted to be attributed to malfunction of our product, for any reason including, but not limited to, damage asserted to
be from improper installation of our purchased Primary Belt Drive components.
This warranty shall not apply to any products which have been subjected to abuse, neglect or accident, nor shall it apply to
any product which has been repaired or modified by any person not specifically authorized in writing by the manufacturer.
THERE IS NO WARRANTY ON BELTS. Due to the differing conditions and circumstances under which all belts are installed
and used, Gates Rubber Company will not warranty any belt for length of service. Regardless of belt type, keeping your
system free of debris and other objects is most important. Remember too, improper handling of the belt can shorten service
life. Do not crimp the belt. Do not twist the belt. Do not pry the belt onto the application. If you’re shipping or storing, try to
eliminate forward and back-bending of the belt.
LIMITATION OF LIABILITY:
THERE ARE NO IMPLIED WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE OF ANY SHIP-
MENT AND THERE IS NO IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS EXCEPT THAT THE MATERIAL
SOLD HEREUNDER SHALL BE OF SELLER’S STANDARD QUALITY, and buyer assumes all risk and liability for all loss,
damage or injury to person or property resulting from the use of said material in manufacturing processes or in combination
with other substances, or otherwise. Except as otherwise provided herein quality shall be in accordance with seller’s specifi-
cations. Final determination of the suitability of the material for the use contemplated by buyer is the sole responsibility of
buyer, and seller shall have no responsibility in connection with such suitability.
8