Rivera Primo Brute IV Extreme - Manual (Page 3)

STEP 6
Apply 3 drops of Blue threadlock to all eight
mount¬ing bolts. Run them in until they seat
equally up against the plate. Check that even con-
tact is made front-to-back. Proceed by tightening
all bolts equally. This is what the mounted motor
plate will look like to this point. Install oil filter nip-
ple if center-mount oil filter is being used.
STEP 7
Install the starter motor using the two 5/16-18 x 3-3/4” socket head cap screws.Place the starter to
the rear of the trans flange and slide the bolts through to the threads in the motor plate.
STEP 8
At this point it’s time to address the starter jackshaft components which are included with the belt
drive kit (see last page for an exploded view of the starter mechanism).
Now it’s time to install the motor plate section on the bike. Position
the plate over the shafts and push forward until contact is made.
Sandwich the front motor plate spacer between the motor plate
and the engine case. Make certain all mounting holes are properly
indexed.
Begin by installing the starter coupler onto the end of the starter motor. Then the remaining pieces . . .
the extender, spring, pinion gear, thrust washer, lockwasher and bolt. Insert this assembly into the
coupler. Make certain the lockwasher is correctly oriented to the slot in the extender. Tighten the bolt.
Bend the locking tab over to keep the bolt from vibrating loose.
3
Brute IV Extreme Instructions_Brute IV Extreme Instructions 4/17/12 3:47 PM Page 3