Rivera Primo Brute IV Extreme - Manual (Page 6)

STEP 17
Tighten the shouldered nuts equally
until they bottom. Then tighten to 30
inch pounds of torque. That’s 30 inch
pounds, not foot pounds.
STEP 18
At this time, adjust the Pro-Clutch ac-
cording to specifications. Re-check
until you are satisfied (see last page
for adjustment specs).
Finally, bend the lock tabs over against
a flat on the nuts. This will prevent the
nuts from coming loose.
STEP 19
Now turn your attention to the starter
nose cap. This piece bolts to the motor
plate and covers the starter jackshaft
assembly.
Looking at the inside of the cap you’ll
notice a vent hole on the top side.
Check to make sure this hole is unob-
structured. It allows air to escape when
the starter is engaged.
STEP 20
Place the starter nose cover over the
protrud¬ing pinion gear and up against
the motor plate. Check to make sure
the holes line-up and the plate sits
squarely up against the mating sur-
face.
6
Brute IV Extreme Instructions_Brute IV Extreme Instructions 4/17/12 3:47 PM Page 6