Alpine CDA-7875 - Manual (Page 10)

8
-EN
Basic Operation
5
To adjust the volume, etc., first press the
SOURCE button and select the AUX mode, then
make the necessary adjustment.
NOTE
When using the Versatile Link Terminal (KCA-410C), you
can connect two external inputs. To select the mode,
press the BAND button on the unit.
Demonstration
This unit has a Demonstration feature which
simulates the display functions.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button to select the DEMO
mode. Each press changes the modes as shown:
∗ CDA-7876 Only
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
3
Press the TUNE button to turn on or off the
DEMO mode.
Each press toggles between DEMO ON and
DEMO OFF.
If no button is pressed for 30 seconds, the
DEMO mode activates.
NOTES
• The initial setting at the factory is “DEMO OFF.”
• To quit DEMO mode, set to “DEMO OFF.”
4
Press the SETUP button again to return to
normal operation.
Setting the AUX Mode (V-Link)
You can input TV/video sound by connecting an
optional Ai-NET/RCA Interface cable (KCA-121B)
or Versatile Link Terminal (KCA-410C) to this
component.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button repeatedly to select
“AUX.”
Each press of the f UP button changes the
modes as shown:
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
∗ CDA-7876 Only
∗∗ Displayed after AUX IN ON is set.
3
Press the TUNE button to toggle the mode
between AUX ON and AUX OFF.
NOTES
• The initial setting at the factory is AUX OFF.
• You can set the AUX mode display by pressing the
g DN or f UP button after AUX ON is set,
select the AUX mode display setting, and then press
the TUNE button.
• When connecting the KCA-410C, you can set two AUX
mode displays.
4
Press the SETUP button to return to normal
mode.
SOURCE TUNE BAND Audio Control
CENTER f X-OVER SETUP
g DN
f UP
→ NORMAL/HI-FI → AMBER* → DIM → SUB
DEMO ← AUX ← SCR ← MUTE ←BEEP ←
→ NORMAL/HI-FI → AMBER∗ → DIM → SUB → BEEP → MUTE
DEMO ← AUX (AUX Mode Display Setting∗∗) ← SCR ←