Alpine CDA-7875 - Manual (Page 9)

7
-EN
3
Press the TUNE button to toggle mode between
SUB-W ON and SUBW OFF.
4
Press the SETUP button after setting the SUB-W
ON.
5
Press the MODE button repeatedly to select the
SUB-W mode.
Press the g DN or f UP button after
selecting the SUB-W mode, and the subwoofer
output phase is toggled SUBW NOR (0
°) or
SUBW REV (180
°).
6
Rotate Audio Control knob until the desired
sound is obtained in each mode.
Sound (Beep) Guide Function
This function will give audible feedback with
varying tones depending upon the button
pressed.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button repeatedly to select
“BEEP.”
Each press of the f UP button changes the
modes as shown:
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
∗ CDA-7876 Only
3
Press the TUNE button to toggle the mode
between BEEP ON and BEEP OFF.
NOTE
The initial setting at the factory is BEEP ON.
4
Press the SETUP button to set the selected
mode.
Turning Mute Mode On/Off
If a device having the interrupt feature is
connected, audio will be automatically muted
whenever the interrupt signal is received from the
device. This function can be turned ON or OFF
from the head unit by following procedure below.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button to select the MUTE
mode. Each press changes the modes as shown:
∗ CDA-7876 Only
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
3
Press the TUNE button to turn on or off the
MUTE mode.
Each press toggles between the MUTE ON and
OFF modes.
NOTE
The initial setting at the factory is “MUTE ON.”
4
Press the SETUP button again to return to
normal operation.
CD Text Scroll Setting
This CD player has the ability to scroll the disc
and track name recorded on CD-Text discs. The
scrolling feature will work with names greater than
8 characters. This feature will not work for the 8
character titles that were input manually.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button repeatedly to select
“SCR”(SCROLL).
Each press of the f UP button changes the
modes as shown:
∗ CDA-7876 Only
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
3
Press the TUNE button to toggle mode between
SCR AUTO and MANU.
• SCR AUTO: the display of CD text is scrolled
continuously.
• SCR MANU: the display is scrolled only when a
disc is loaded or when a track is changed and the
text information exceeds 8 digits.
4
When the setting is completed, press the SETUP
button to return to the normal mode.
NOTES
• Initial mode is “SCR MANU.”
• The unit scrolls only CD text names. The disc titles
input manually (refer to page 13) cannot be scrolled.
• The display of CD text will scroll even for text less
than 8 characters.
→ SUB-W → BALANCE
VOLUME
←
FADER
←
→ NORMAL/HI-FI → AMBER* → DIM → SUB
DEMO ← AUX ← SCR ← MUTE ←BEEP ←
→ NORMAL/HI-FI → AMBER* → DIM → SUB
DEMO ← AUX ← SCR ← MUTE ←BEEP ←
→ NORMAL/HI-FI → AMBER* → DIM → SUB
DEMO ← AUX ← SCR ← MUTE ←BEEP ←