SawStop 1.75HP - Manual (Page 27)

SawStop 10” Professional Cabinet Saw 25
Assembling Y
our
Saw
Assembling Your Saw
Mounting the Accessory Holders
8. Your saw comes with two tool holders to store saw accessories. The blade wrench holder provides a place to
hang the wrenches that came with your saw. The accessory tool holder provides a place to store your riving
knife, miter gauge and blade guard. The hardware required to mount the two accessory holders is located
in the area with the gray background on the Table Saw Hardware Pack. To mount the blade wrench holder,
remove the blade wrench holder, one M6 x 12 button head screw and one M6 lock washer from the Table Saw
Hardware Pack. Place the lock washer on the screw, insert the screw through the hole in the blade wrench
holder and then thread the screw into the hole on the left side of the cabinet behind the switch box (see Fig. 30)
Tighten the screw with a 4mm hex key.
To install the accessory tool holder, locate the
accessory tool holder and remove the
other M6 x 12 button head screw and M6 lock
washer from the Table Saw Hardware Pack.
Place the lock washer on the screw and insert
the screw through the hole at the bottom of the
accessory tool holder. Mount the accessory tool
holder to the cabinet by slipping the ends of
the hooks on the side of the tool holder into the
corresponding slots on the front lower corner of
the right side of the cabinet and threading the
screw into the hole in the cabinet (see Fig. 31).
Tighten the screw with a 4mm hex key.
Congratulations, your saw is now assembled.
Note: You must install a rip fence prior to using the saw. Refer to the manual
accompanying your rip fence for instructions on how to install the fence.
14 15
Fig. 31
accessory
tool holder
Mounting the Switch Box
Hardware for Step 7
Button Head Socket Screws,
M6 x 20 (2)
9
Switch Box Keys (2)
Installing the Handwheels
Hardware for Steps 2-3
1 Keys,
5 x 5 x 25 (2)
Set Screws,
M6 x 8 (2)
2
Mounting the Dust Port
Hardware for Step 4
Mounting
the
Motor
Cover
Hardware for Step 5
F
Mounting the
Wrench & Tool
Holders
Hardware for Step 8
Motor
Cover
Rod
5
Blade
Wrench Holder
13
Button Head Screws,
M6 x 12 (2)
15 Lock Washers,
M6 (2)
14
12
Mounting the Extension Wings
Hardware for Step 6
Washers,
M8 (8) 6 Hex Bolts, M8 x 16 (8) 8 Lock Washers, M8 (8) 7
Tools
Lock Washers,
M6 (2) 10
Washers, M6 (2) 11
Hex Key, M8 (1)
Blade Spacing
Adjustment Gauge (1)
Hex Keys: M3 (1), M4 (1), M5 (1), M6 (1)
Lock Washers,
M5 (3) 4
Button Head Screws,
M5 x 3 x 15 (3) 3
14
15
13 blade wrench holder
Fig. 30