Muxlab VGA 1x4 Hub - Manual (Page 8)

© MuxLab Inc. VGA 1x4 Distribution Hub Installation Guide
Page 8
3.3. Pre-Installation Checklist
The VGA 1x4 Distribution Hub works in conjunction
with the Active VGA Balun II Kit (500140) and Active
VGA Balun Receiver (500142).
1. Verify that you have all the components necessary to
install the complete system and determine the final
location for each piece of equipment.
2. One (1) Active VGA Balun Kit (500140) is needed
to support the first display screen.
3. One (1) Active VGA Balun Receiver (500142) is
required for each additional display.
4. Consult the Technical Specifications to determine
whether the Hub and the Active VGA Baluns are
within MuxLab distance limitations for Remote
Power. If so, then only the Hub needs to be
powered.
5. If extended distance is required beyond the limits of
Remote Power, verify that each Active VGA Balun
is powered by its own power supply. Additional
12VDC/0.5A balun power supplies may be ordered
from your MuxLab distributor (P/N: 500144).
6. Verify that the screen resolution and cable lengths
are within MuxLab specifications (see Technical
Specifications).