Attero Tech InBox/OutBox - Manual (Page 18)

InBox / OutBox
User Manual
 Attero Tech LLC 2010 Page 13 614-00005-04
4.3.1 – Output Limiter
The output limiter is a fixed ratio limiter with the ratio set to 100:1.
Each limiter has four controls per channel.
o A bypass toggle control,
o A threshold control which ranges from -100 dB to 0 dB,
o An attack control which ranges from 1 ms to 1 s
o A release control that ranges from 10 ms to 30 s.
The bypass control is active if the indicator is showing red. When active, the limiter
controls will have no effect on the audio signal irrespective of their settings. Changing
the threshold, attack, and release values with the bypass enabled also has no effect.
4.3.2 – Output Gain
The Input Gain control allows the overall level of the signal to be adjusted before it is fed
into the mixer.
The fader sets the gain from -100 dB to +12 dB. The meter alongside shows the current
level after all the input processing has taken place, including the gain factor. There is also a
clipping LED.
The gain control also has two toggle indicators. The upper one marked with an “M” is the
“Mute” button. The lower button marked with an “I” is the “Polarity Invert” button.
4.3.3 – Delay
The delay control adds buffering to delay the audio signal. If the control is set to 0, the control
is essentially bypassed.
A maximum delay of up to 10 ms can be added.
Figure 17 - Output
Gain Controls
Figure 16 - Local Output
Limiter Controls
Figure 18 - Delay
Controls