Chemglass CG-15001 Series User Manual
Page 8
8
6. Press and hold in both the and keys until the temperature is displayed, then release both keys.
PID Mode of Operation
The Controller can be set back to the PID Mode by using the following sequence.
1. Press and hold in both the and
keys until the word “tunE” appears in the display, then release both keys.
2. Press the
key until the letters “CyC.t” appear in the display.
3. While holding in the key, press the or
key until the value “30” appears in the display.
4. Press the
key until the word “bAnd” is displayed.
5. While holding in the key, press the
key until the value “10” is displayed, then release both keys.
6. Press and hold in both the and keys until the temperature is displayed, then release both keys.
Q
Q
u
u
i
i
c
c
k
k
T
T
i
i
p
p
s
s
1) To reset alarms and error messages: Press and keys together briefly and release.
2) The temperature set point can be displayed at anytime by pressing the key.
3) To exit from a programming mode and return to normal operations: Press and hold both and keys for three (3)
seconds or allow the auto-exit program to take effect after 60 seconds of inactivity.
S
S
a
a
f
f
e
e
t
t
y
y
–
–
H
H
e
e
a
a
t
t
e
e
r
r
R
R
e
e
s
s
t
t
r
r
i
i
c
c
t
t
i
i
o
o
n
n
s
s
Use only resistive loads that are safely operated at 120VAC and require less than 10 amps or damage to the
Controller and a safety hazard may result.
Do not use the Controller to regulate an exothermic process.
CAUTION: PARAMETER SETTINGS IN LEVEL 3 AFFECT THE FAIL SAFE STATE