EZ Dupe Portable USB 2 Copy Duplicator & Tester - Manual (Page 6)

II. Function Introduction
1. Copy
The 2CUSB Portable USB Duplicator copies data from source Flash devices to target Flash devices. The
default setting copy area is “Data Only”. If you would like to change the copy area from “Data Only” to
“ Whole HDD” or “All Partitions”, please refer to function [5.1 Copy Area] to select other copy modes.
Copy steps:
Insert source Flash Device (Master) and target Flash devices into duplicatorÆSelect [1. Copy]ÆPress
[OK]Æ The LCD will show the number of target Flash devices detected and Press [OK] to start
copyingÆCopy processingÆCopy finishedÆPress[ESC] to finish copy.
In <Data Only> Mode:
**Do not remove any Flash device while it is processing.
** It is strongly recommended that the target devices and source (master) have the same capacity.
** After copying, the target flash device data and format will be the same as the source flash device.
Original data on target flash devices will no longer exist.
** When the copying process is in progress, the green LED will flash. When the process has finished the
green LED will stop flashing but will remain illuminated. If an error occurs the red LED will illuminate.
2. Compare
This function is used to check if the data on the source Flash device is identical to the copied Flash
devices after duplication.
Compare Steps:
Insert Flash devices into duplicatorÆSelect [2. Compare] ÆPress [OK] ÆCompare
ProcessingÆCompare finishedÆ Press [ESC] to finish compare.
5