Kramer Electronics VP-731 - Manual (Page 34)

VP-731 - Configuring the VP-731 via the OSD MENU Screens 29
29
7.6 The Geometry Screen
Figure 19: Geometry Screen
Setting Function Default
Application Select the output application: Keystone, Anyplace
or Rotation
Keystone
Location Select the location of the display: Front, Rear,
Ceiling or Rear ceiling
Front
Horizontal Keystone Adjust the horizontal keystone: -40 to 40
If the projector is located at an angle to the left or
right of the screen
0
Vertical Keystone Adjust the vertical keystone: -30 to 30
If the projector is located at an angle above or
below the screen
0
Diagonal Projection Move the location of each corner of the display
separately (horizontal and vertical): Top Left, Top
Right, Bottom Left, Bottom Right or Reset (to reset
diagonal projections settings)
Top Left
Pincushion/Barrel Adjust the pincushion or barrel appearance of the
screen: -20 to 20
0
Rotation Rotate the display by 180 degrees clockwise or
counterclockwise: -180 to 180
0
Reset all Resets the geometry values to their default value
The settings available for each application are defined in the following table:
Application Available Settings
Keystone Location, horizontal keystone, vertical keystone,
pincushion/barrel and Reset all
Anyplace Location, Diagonal Projection and Reset all
Rotation Location, pincushion/barrel, Rotation and Reset all