Kramer Electronics VP-771 - Manual (Page 27)

22 VP-771 - The OSD Menu
Setting Function
Window
Customization Select the position and the size of the selected window: H Position, H Width,
V Position and V Height (see
Section 6.2.1.2 and Section 6.2.1.1 ) M / P
The value range is dynamic. The FW prevents windows from exceeding the
boundaries or over-sizing. The position and size of the windows are saved to the
system.
The size and position of the customized window (Main or PiP) remain valid even
when toggling the PIP button (front panel, remote control transmitter or protocol
command).
The customized setup is cancelled only by explicitly selecting a preset Display Mode
(see first item in this table) or if a new customized setup is created.
Use the front panel + and – buttons, IR remote control transmitter or Web page to
set the position and height of the Main and/or PiP windows
The PiP window maximum horizontal active image area is 1600
pixels
The display mode setup, shown in Figure 9 , is part of the entire system control and
the selected Single Window also shows the current aspect ratio (Best Fit):
Figure 9: Select the Display Mode
6.2.1 Window Customization
Window customization lets you change the size and position of a selected window.
Make sure that you have control over the window that requires customization (Main
Window Control or PiP Window Control). If not, select it via the OSD item in the
Miscellaneous menu, see Section 6.8 .
i